Physics

You drill a well to a depth of 100-m. Find the difference in water pressure, comparing the top and bottom of the well

asked by Stuart
  1. the metric unit of pressure is the Pascal (Pa) ... one Newton of force over one square meter

    a cubic meter of water has a mass of a thousand kg (a metric ton)
    ... it exerts a force of 9.81 kN

    stacked 100 high, the pressure at the bottom is ... 981 kPa

    posted by Scott
  2. take a 1 inch area pipe down.
    pressure=densitywater*height*9.8N/kg

    posted by bobpursley

Respond to this Question

First Name

Your Answer

Similar Questions

  1. Physics uncertainties

    A flat head drill bit is used to drill holes of small depth. The drill bit can drill holes with a diameter size of (40 ± 0.5)mm. The depth of the hole has an uncertainty of ±1mm. If the total percentage uncertainty of the volume
  2. physics

    A graduated cylinder is inverted in a very large bucket of water. The depth of the water in the container is 6 m and the top of the bucket is open to the air in the room. The mouth (bottom) of the graduated cylinder is 4 m above
  3. physics

    I recently did an experiment where I measured pressure at a few heights. The question I cam having trouble with is how to find the density of the air between the top and bottom. The difference in pressure from the top to bottom is
  4. physics

    The deepest place in the ocean is the Marianas Trench in the western Pacific Ocean, which is over 11.0 km deep. On January 23, 1960, the research sub Trieste went to a depth of 10.915 km, nearly to the bottom of the trench. This
  5. physics

    If a scuba diver descends too quickly into the sea, the internal pressure on each eardrum remains at atmospheric pressure while the external pressure increases due to the increased water depth. At sufficient depths, the difference
  6. Physics - Bernouli

    Water flows with constant speed through a garden hose that goes up a step 20.0 cm high. 1. If the water pressure is 143 kPa at the bottom of the step, what is its pressure at the top of the step? Now suppose the cross sectional
  7. Calculus - Hydrostatic Pressure

    Please check my work: Find the hydrostatic pressure on one end of a water trough full of water, the end of which is a trapezoid with given dimensions: top of trapezoid = 20 feet, sides of trapezoid both = 8 feet, bottom of
  8. Physics

    (a) Calculate the absolute pressure at the bottom of a fresh-water lake at a depth of 23.2 m. Assume the density of the water is 1.00 103 kg/m3 and the air above is at a pressure of 101.3 kPa. Pa (b) What force is exerted by the
  9. Intro to Physics

    (a) Calculate the absolute pressure at the bottom of a fresh-water lake at a depth of 25.6 m. Assume the density of the water is 1.00 103 kg/m3 and the air above is at a pressure of 101.3 kPa. (b) What force is exerted by the
  10. Physics

    A container is filled to a depth of 20cm with water. on top of the water floats a 30.0 cm thick layer of oil with specific gravity of 0.700, what is the absolute pressure at the bottom? Please help!

More Similar Questions