Bio-URGENT

OK i did a lab in which we had to calculate the rate of reaction by observing how much gas was produced by the experiment. to do this we used a ubside down graduated cylinder in a tub of water and placed a gas collection tube between the testube and the graduated cylinder

WHat possible sourced of error can be caused by this method of gas collection

ANY HELP would be appreciate =)

  1. 👍 0
  2. 👎 0
  3. 👁 147

Respond to this Question

First Name

Your Response

Similar Questions

  1. Chemistry

    Recall the reactions for this lab: S2O82- + 2I- → 2SO42- + I2 (slow) Reaction 1 The one that delays the solution turning blue: I2 + 2S2O32- → 2I- + S4O62- (fast) Reaction 2 b. All the S2O32 is consumed when the color change

    asked by Alexander on February 19, 2017
  2. Chemistry

    Recall the reactions for this lab: S2O82- + 2I- → 2SO42- + I2 (slow) Reaction 1 The one that delays the solution turning blue: I2 + 2S2O32- → 2I- + S4O62- (fast) Reaction 2 b. All the S2O32 is consumed when the color change

    asked by Anonymous on February 19, 2017
  3. Chemistry - URGENT

    So, I go to high school in Texas and we have this AP Chem lab due online tomorrow night by midnight and I need some serious help on these questions:   Lab Temp 0.2°C   Experiment Trial Time in seconds Trial 1 Trial 2 Average

    asked by Jordan on March 16, 2013
  4. Chemistry

    So, I go to high school in Texas and we have this AP Chem lab due online tomorrow night by midnight and I need some serious help on these questions:  Lab Temp 0.2°C  Experiment Trial Time in seconds Trial 1 Trial 2 Average

    asked by Jordan on March 16, 2013
  5. Chemistry - reaction kinetics

    So, I go to high school in Texas and we have this AP Chem lab due online tomorrow night by midnight and I need some serious help on these questions:   Lab Temp 0.2°C   Experiment Trial Time in seconds Trial 1 Trial 2 Average

    asked by Jordan on March 16, 2013
  6. Chemistry

    I did a lab, an kinetics lab (iodide clock) and in my lab report I have to calculate the initial rate in mol L-1 s-1 and I'm not sure how to do that. I have the [I-] and [S2O82-] in mol L-1 already. The reagents are [KI] [NaCl]

    asked by Dan on February 28, 2016
  7. AP Chemistry

    iN A LAB, the orders of two reactants, A and B, were determined experimnetally to be 2 and 3 respectively. a. write the rate law for this reaction. c. what would happen to the rate of the reaction if A were Doubled? d. what would

    asked by Sara on February 24, 2015
  8. Chemistry

    A reaction is said to be diffusion controlled when it occurs as fast as the reactants diffuse through the solution. The following is an example of a diffusion controlled reaction. The rate constant for this reaction is 1.4x1011

    asked by Kevin on May 19, 2009
  9. Chemistry

    I am trying to figure out how to calculate the reaction rate. In my question the reaction rate is: 1/2x molarity of sodium thiosulfate/reaction time Then I have to compare the rates of runs 1-3 and determine the orders of the

    asked by Zach on October 1, 2012
  10. Chemistry

    1. The following data was collected for the reaction between hydrogen and nitrogen monoxide. The time recorded corresponds to a N2 concentration change of 5.3 x 10-4 M. 2H2(g) + 2NO(g)  2H2O(g) + N2(g) Trial [H2], M [NO], M

    asked by Jason on June 4, 2013
  11. Chemistry

    A reaction of importance in the formation of smog is that between ozone and nitrogen monoxide described by O3(g)+NO(g) --> O2(g)+NO2(g) The rate law for this reaction is: rate=k[O3][NO] Given that k = 2.87 × 106 M–1·s–1 at a

    asked by Ceamus Angelina on July 1, 2018

More Similar Questions