# chem

I can't seem to figure this out!
I know I have to use mass to mass conversions though.

Can someone help me out?

Hydrochloric acid can dissolve solid iron according to the following equation: Fe + 2HCl to form FeCl2 + H2

a) How much HCl in grams would you need to dissolve a 2.8-g iron bar on a padlock?

b) How much H2 would be produced by the complete reaction of the iron bar?

Step 1. Write the balanced equation. You have that.
Fe + 2HCl ==> FeCl2 + H2

Step 2. Convert what you have from grams to mols.
mols = g/molar mass
mols Fe = 2.8 g/56 = o.05 mols

Step 3. Using the coefficients in the balanced equation, convert mols of what you have (in this case mols Fe) to mols of what you want (in this case mols HCl).

0.05 mols Fe x (2 mols HCl/1 mol Fe) = 0.05 x 2 = 0.10 mols HCl.

Step 4. Convert mols of HCl to grams.
grams HCl = mols HCl x molar mass HCl.

Post your work if you get stuck. You can follow this same procedure to work part b and any other stoichiometry problem you may have. ALSO, note that I rounded and used 56 for the atomic mass of Fe. You will need to go back through it and use a more exact number. Good luck.

0.05 mol Fe *2 mol HCl/ 1 mol Fe= .10 mol HCl

0.10 mol HCl *36.46g HCl/2mol HCl = 1.82 g HCl

correct?

1. 👍 0
2. 👎 0
3. 👁 839

## Similar Questions

1. ### Astronomy Question about Neutrinos

I can't seem to figure this out, I know that neutrinos have nonzero mass but I don't know how that can help me figure this out The mass of a neutrino is zero. equal to the mass of a proton. equal to the mass of an electron. less

asked by Kaitlyn on May 4, 2014
2. ### physics

The drawing shows a human figure approximately in a sitting position. For the purposes of this problem, there are three parts to the figure, and the center of mass of each one is shown in the drawing. These parts are: (1) the

asked by riley on October 16, 2011
3. ### physics

The drawing shows a human figure approximately in a sitting position. For the purposes of this problem, there are three parts to the figure, and the center of mass of each one is shown in the drawing. These parts are: (1) the

asked by riley on October 15, 2011
4. ### physics

For the purposes of this problem, there are three parts to the figure, and the center of mass of each one is shown in the drawing. These parts are: (1) the torso, neck, and head (total mass = 40.4 kg) with a center of mass located

asked by Anonymous on March 27, 2014
5. ### physics

In the Figure the pulley has negligible mass, and both it and the inclined plane are frictionless. Block A has a mass of 1.3 kg, block B has a mass of 2.7 kg, and angle è is 26 °. If the blocks are released from rest with the

asked by nirali on March 22, 2009
6. ### physics

In the Figure the pulley has negligible mass, and both it and the inclined plane are frictionless. Block A has a mass of 1.3 kg, block B has a mass of 2.7 kg, and angle è is 26 °. If the blocks are released from rest with the

asked by sweety on March 22, 2009
7. ### physics

A mass spectrometer as shown in the attached figure is used to separate isotopes. If the bean emerges with a speed of 363 km/s and the magnetic field in the mass selector is 1.4 T, what is the distance between the collectors for

asked by Nelly on April 23, 2010
8. ### physics

In the Figure the pulley has negligible mass, and both it and the inclined plane are frictionless. Block A has a mass of 1.3 kg, block B has a mass of 2.7 kg, and angle è is 26 °. If the blocks are released from rest with the

asked by nicks on March 22, 2009
9. ### Physics

The figure is just mass A on top of mass B. There are no forces or anything shown. Block A, of mass 3.2 kg, is on block B, of mass 7 kg, as shown in the above figure. The lower block is on a frictionless surface while the

asked by Ana on March 12, 2017
10. ### physics

A 1-kg mass (the blue mass) is connected to a 9-kg mass (the green mass) by a massless rod 67 cm long, as shown in the figure. A hole is then drilled in the rod 40.2 cm away from the 1-kg mass, and the rod and masses are free to

asked by hania on March 25, 2012
11. ### physics

A 1-kg mass (the blue mass) is connected to a 8-kg mass (the green mass) by a massless rod 67 cm long, as shown in the figure. A hole is then drilled in the rod 40.2 cm away from the 1-kg mass, and the rod and masses are free to

asked by hania on March 25, 2012

More Similar Questions