Physics

A horizontal water pipe goes from a large diameter to a small diameter and then back to the first diameter as shown in the figure below. The level of water (8cm in the larger tube and 4 cm in the constricted tube) in the small vertical tubes provides us with information about the water pressure in the two different sizes of pipe. The inside diameter of the larger pipe is 2.60 cm and water travels through both sizes of pipe with a volume flow rate of 2.00 10-4 m3/s. Determine the inside diameter of the smaller pipe.

I have attempted many times by combining Bernoulli's Equation with the equation of continuity to no avail. Please help.

  1. 👍 0
  2. 👎 0
  3. 👁 693

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in figure below, the pressure is P1 = 1.75X104 Pa and the pipe diameter is 6.00 cm. At another point y = 0.250 m higher, the pressure is P2 =

  2. Physics

    Please someone help..A horizontal pipe 10.0cm in diameter has a smooth reduction to a pipe 5.0cm in diameter. If the pressure of the water in the large pipe is 80000Pa and the pressure in the small pipe is 60000Pa at what rate

  3. physics, buoyance

    Water flows at a rate of 25L/min through a horizontal 8.0-cm-diameter pipe under a pressure of 5.7Pa . At one point, calcium deposits reduce the cross-sectional area of the pipe to 40cm2 . Part A What is the pressure at this

  4. Physics

    Water flows into one end of a horizontal, cylindrical pipe at 2.0 m/s. The pipe then narrows until its diameter at the opposite end is only 1/3 of that at the beginning. (a) What is the flow speed at the narrow end of the pipe?

  1. Physic

    1. Water at a pressure of 3.00 x 10 5th Pa flows through a horizontal pipe at a speed of 1.00 m/s. The pipe narrows to one-fourth its original diameter. What is the speed of the flow in the narrow section? Not sure was

  2. maths

    To fill a swimming pool two pipes are to be used.If the pipe of larger diameter I'd used for 4 hours and the pipe of smaller diameter for 9 hours only half the pool can be filled .Find ,how long it would take for each pipe to fill

  3. physics

    Two identical wooden barrels are fitted with long pipes extending out their tops. The pipe on the first barrell is 1 foot in diameter, an the pipe on the second barrell is only 1/2 inch in diameter. When the larger ptpe is fill

  4. physics

    The water supply of a building is fed through a main entrance pipe 6cm in diameter. A 2cm diameter faucet tap positioned 2m above the main pipe fills a 25 liter container in 30s. (a) What is the speed at which the water leaves the

  1. Fluid Mechanics

    Water flows into a cylindrical tank through pipe 1 at a rate of 25 ft/s and leaves through pipe 2 at 10 ft/s and through pipe 3 at 12 ft/s. Pipe 4 is an open air vent. Internal diameters of the pipes are: D1=3 in, D2= 2 in, D3=2.5

  2. Physics

    For an ideal fluid flowing through a horizontal pipe, Bernoulli's principle and the continuity equation state that the pressure within the pipe does which of the following? Pressure descreased pipe diameter increase?

  3. physics

    In the figure below, the fresh water behind a reservoir dam has depth D = 13 m. A horizontal pipe 6.0 cm in diameter passes through the dam at depth d = 6.0 m. A plug secures the pipe opening. (a) Find the magnitude of the

  4. Physics

    A horizontal pipe, 10 cm in diameter, has a smooth reduction to a pipe 5 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, what is the flow speed of

You can view more similar questions or ask a new question.