# phy 111

1 An ideal gas undergoes a cycle of processes as shown in the p-V diagram gases . Which statement correctly describes the situation?
The internal energy of the gas increases over one complete cycle
Over the entire cycle, work is done by the gas.
The gas absorbs more heat than it releases heat over the whole cycle
The gas gives out more heat than it absorbs over the whole cycle.

2 A fixed mass of an ideal gas slowly releases 1500 J of heat and as a result contracts slowly, at a constant pressure of 2.0 x 104 Pa, from a volume of 0.050 m3 to 0.025 m3 . What is the effect on the internal energy of the gas?
It decreases by 2000 J.
It decreases by 1000 J.
It is unchanged.
It increases by 1000 J.

3 A dam is thicker at the bottom than at the top because
surface tension exists only on the surface of liquids.
it looks better
water is denser at deeper levels.
water pressure is greater with increasing depth.

4 A completely submerged object always displaces its own
density of fluid.
weight of fluid.
volume of fluid.
all of these

5 When gas in a container is squeezed to half its volume, its density
halves.
doubles.
remains the same.

6 Airplane flight is best illustrated by
Boyle's law.
Bernoulli's principle.
Archimedes' principle.
Heat law

7 What is the buoyant force acting on a 10-ton ship floating in the ocean
10 tons
more than 10 tons
less than
depends on density of seawater

8 How much pressure do you experience, when you balance a 5 kg ball on the tip of your finger, which has an area of
1cm2?
490 kPa
4600 Pa
34 N

9 If you wish to warm 100 kg of water by
20oC
for your bath, how much energy is required? (Specific heat capacity of water is
1cal/goC
500 kcal
1000 kcal
2000 kcal.
3000 kcal

10 Heat can be defined as------------------------
the change in temperature of a body
the flow of temperature from one body to another
energy that flows from place to place as a result of the difference in temperature between them
the measure of hotness or coolness of a body

11 Two bodies may be said to be in thermal equilibrium if
the bodies are thermally insulated from one another
the bodies are not in thermal equlibrium with another body
if one body loses heat to the other
if there not net flow of heat between the two bodies two bodies in thermal contact

12 Heat capacity has units as
J/kg.K
J/mol.K
J.ohm/sec.K2
W/m.K

13 An engine absorbs 2000J of heat from a hot reservoir and expels 750J to a cold reservoir during each operating cycle. What is the power output of the engine if each cycle lasts for 0.5 seconds?
750W
1750W
3000W
2500W

14 An engine absorbs 2000J of heat from a hot reservoir and expels 750J to a cold reservoir during each operating cycle. How much work is done during the cycle?
1250J
750J
2000J
350J

15 An engine absorbs 2000J of heat from a hot reservoir and expels 750J to a cold reservoir during each operating cycle. What is the efficiency of the engine?
50%
62.5%
74.2%
85.6%

16 Calculate the work done on the system when 1.00 mol of gas held behind a piston expands irreversibly from a volume of
1.00dm3
to a volume of
10.0dm3
against an external pressure of 1.00 bar.
-900 J
-1800 J
-1900 J
-60 J

17 A perfect gas expands reversibly at a constant temperature of 298 K so that its volume doubles. What is the change in the molar internal energy of the gas?
−0.125Jmol−1
0Jmol−1
983Jmol−1
1Jmol−1

18 When the junctions of two dissimilar metals are maintained at different temperatures an electromotive force is is set up in the circuit of which these junctions are part. A pair of juntions of this kind and the effect are known respectively as
thermistor and Peltier effect
resistance thermometer and Joule effect
pyrometer and Joule effect
thermocouple and Seebeck effect

19 Which of the following is not an equation of state of a thermodynamic system?
Charles law
Ideal gas law
Van der Waals equation
Kirchoff's junction rule

20 Units for thermal conductivity
J/kg.K
J/mol.K
J.ohm/sec.K2
W/m.K

1. 👍 0
2. 👎 0
3. 👁 159
1. 3c, 4c, 5c, 6b, 7a, 8a, 9b, 10c, 11d, 12a, 13d, 14a, 15b, 16a, 17b, 18d, 19d

1. 👍 0
2. 👎 0
posted by Dennis
2. 1c2d

1. 👍 0
2. 👎 0
posted by preye
3. 20.d

1. 👍 0
2. 👎 0
4. the internal energy of the gas increases over one complete cycle

1. 👍 0
2. 👎 0
5. B a d c a a c c d b b a b a d d

1. 👍 0
2. 👎 0
posted by isaac

## Similar Questions

1. ### Heat and properties of matter

An ideal gas unergoes a cycle of processes as shown in d p-v diagram gases, which statement correctly escribe the situation a. The internal energy of the gas increases over one complete cycle b. Over the entire cycle, work is done

asked by Mutiyat on April 23, 2015
2. ### Physics

Suppose a monatomic ideal gas is changed from state A to state D by one of the processes shown on the PV diagram. Find the total work done on the gas if it follows the constant temperature path A-C followed by the constant

asked by Dan on December 6, 2010
3. ### Physics

A heat engine has the three step cycle shown above. Starting from point A, 1 L (liter) of ideal gas expands in the isobaric (constant pressure) process A to B at P = 2 atm. B to C is isovolumetric process at V = 5 L, and C to A is

asked by Jason on May 7, 2010
4. ### Chem

a container of 2.00 moles of an ideal gas as 1000 K undergoes a constant pressure and volume process in which the number of moles is increased to 5moles. what is the final temperature of the gas. How do I start this? Do I somehow

asked by Don on November 30, 2010
5. ### Chemistry

1. Out of all the "8" unknown gases, which one is the most likely to depart from the ideal gas behavior? Why? 2. Out of all the "8" unknown gases, which one is most likely to behave closest to that of an ideal gas? Why?

asked by Michael on November 13, 2011
6. ### chemistry

Study the reaction. 2A(?) + B(g) ⇌ A2B(g) Both B and A2B are gases. When the reaction vessel is compressed, the equilibrium position does not change. What conclusion can we draw about the state of “A” from this data? A. "A"

7. ### physics

A monoatomic ideal gas has Cp= 5R/2 a) four moles of the gas undergoes a process in which the temperature of the gas increases from 300 K to 500 K while the pressure is kept constant at 2.00 x 105 Pa. What is the change in the

asked by Julie on April 24, 2017
8. ### Physics

A heat engine has the three step cycle shown above. Starting from point A, 1 L (liter) of ideal gas expands in the isobaric (constant pressure) process A to B at P = 2 atm. B to C is isovolumetric process at V = 5 L, and C to A is

asked by Jason on May 8, 2010
9. ### Physics difficult... chris help again plz.

A heat engine has the three step cycle shown above. Starting from point A, 1 L (liter) of ideal gas expands in the isobaric (constant pressure) process A to B at P = 2 atm. B to C is isovolumetric process at V = 5 L, and C to A is

asked by Jason on May 8, 2010
10. ### science

Most of the processes that influence the hydrologic cycle are: A. biological processes. B. physical processes. C. ecosystem processes. D. wind processes. is it B

asked by Amy on July 27, 2013
11. ### Physics

A heat engine carries 2.60 mol of an ideal monatomic gas around the cycle shown in the figure. Process 1-2 takes place at constant volume and takes the gas from 300 K to 600 K, process 2-3 is adiabatic and takes the gas from 600 K

asked by Anonymous on April 19, 2015

More Similar Questions