
posted by avela
Respond to this Question
Similar Questions

Physics
Salt water is poured into a U tube until it stands 0.250 m high in each arm. Oil is then added slowly to one arm until the salt water in the other arm stands 0.300 m high. The free surface of the oil then stands at 0.321 m high. 
AP Calculus
Oil leaks out from a damaged oil tanker and forms a circle around the tanker. If the radius of the circle of oil is increasing at 25m/min, find the rate of change of the area when the radius is 20km 
math
The level of oil in a storage tank buried in the ground can be found in much the same way as a dipstick is used to determine the oil level in an automobile crankcase. Suppose the ends of the cylindrical storage tank are radius of 
physics 1
) An oil tankerâ€™s engines have broken down, and the wind is blowing the tanker straight toward a reef at a constant speed of 1.5 m/s (Fig.1). When the tanker is 500 m from the reef, the wind dies down just as the engineer gets 
Calculus
An oil tank in the shape of a right circular cylinder, with height 30 meters and a radius of 5 meters is twothirds full of oil. How much work is required to pump all of the oil over the top of the tank? (The density of oil is 820 
math
An oil storage tank is 50 feet across and 40 feet high and filled with oil to a depth of 10 feet. How many cubic feet of oil is in the tank? 
Math
one tank have 550 liter oil 2/5 part oil is sold and 1/5 is poured from tank how many oil is remaining in the tank 
Physics
A Ushaped tube is filled mostly with water, but some vegetable oil has been added to both sides of the U tube. On the right side of the tube, the depth of oil is 5.00 cm . On the left side of the tube, the depth of the oil is 
Math
An oil tank is the shape of an inverted right circular cone with the pointed end down. The tank is 15 feet tall and is 12 feet in diameter at the top. At 1:00pm, the tank has oil 5 feet deep in it. Oil is pouring in at 5 cubic 
Physics
an open tank contains a layer of oil floating on top of a layer of water (of density 1000 kg/m3) that is 3.0 m thick, as shown. What must be the thickness of the oil layer if the gauge pressure at the bottom of the tank is to be