torque to move a block of m=200kg for 10m at an angle of 25 degree with a speed of 20m/s.

1 answer

Why would I need a torque to move straight?

why would I need any force to move at constant velocity?
I am wondering who assigned this question.

Similar Questions

A solid block resting on a horizontal surface needed a pull of 40N inclined at angle 25 degree to the plane just to move it, but

Top answer: To determine the weight of the block and the coefficient of friction, we need to analyze the forces Read more.
if a 10kg block with a velocity of 10m/s collide with a stationary block of 5kg , after collission the two blocks move stick

Top answer: (m1+m2)V = m1*V1 (10+5)V = 10*10 Solve for V. Read more.
A 12 kg block is released from rest on a 30 degree fricitonless incline. Below the block is a spring that can be compressed 2 cm

Top answer: a .w =588.6 N b.v=√1177.2÷√12 metre per second Read more.
If you push the outer edge of a 1.05-m-wide door with a 23.0-N tangential force, what torque results? What is the torque if you

Top answer: answer 1 = 23*1.05 abswer 2 = 23*1.05*cos 45 Read more.
If you push the outer edge of a 1.05-m-wide door with a 23.0-N tangential force, what torque results? What is the torque if you

Top answer: 1.05 * 23 1.03 * 23 * (1/2)sqrt 2 Read more.
A force of 40 N is applied at an angle of 30oabove the horizon to a 5 kg block that is at rest on a rough horizontal surface.

Top answer: You know friction force is equal to the horizontal pulling force (adjusted for acceleration). Read more.
A block with a mass of 1.0kg is lifted up slowly from ground (0m) to height of 0.51m.block is slowly displaced horizontally by

Top answer: NO WORK IS DONE TO MOVE HORizontaly !!!!!! there is no horizontal forCE !!! Do not be fooled !!! m g Read more.
A ball is projected with velocity 10m/s at an angle of 30 degree with the horizontal surface.the speed of the ball after 1s will

Top answer: To find the speed of the ball after 1 second, we need to break down the initial velocity into Read more.
3. A person exerts a force of 55 N on the end of a door 74 cm wide. What is the magnitude of the torque if the force is exerted

Top answer: Torque= (F)sinTheta(r) Given: F=55N d= 74cm (converted to M=0.74M) Theta=90degrees. Since, Read more.
A 1.65-kg aluminum block and a 6.85-kg copper block are connected by a light string over a frictionless pulley. The two blocks

Top answer: To find the acceleration of the two blocks and the tension in the string, we need to use Newton's Read more.