# physics

Voltage=12V. R1=2.0ohms and R2=4.0ohms. Find the power used by R2.

1. 👍 0
2. 👎 0
3. 👁 99
1. I do not know

1. 👍 0
2. 👎 0
posted by Damon

## Similar Questions

1. ### FGS

Two bulbs each of resistance 2.0ohms are connected in parallelwith a battery.calculate the current flowing through any of the bulbs if the voltage of the battery is 0.2v

asked by Karlos on September 24, 2015
2. ### physics

the resistance of a platinum resistant thermometer is 1.2ohms. when the measuring in Kelvin temperature of oil and 1.0ohms at the triple point of water. find T

asked by Izrel on June 10, 2016
3. ### PHYSICS

A GALVANOMETER WITH COIL RESISTANCE 12.0OHMS SHOWS FULL SCALE DEFLECTION FOR A CURRENT OF 2.5MA HOW WOULD YOU CONVERT IT INTO A VOLTMETER OF RANGE 0 TO 10VOLTS

A resistance in a circuit is 470§Ù ¡¾ 10%. When a meter with a full-scale voltage of 25V and error of ¡¾ 3% is used to measure the voltage across the resistance, the voltage was read as 12V. Obtain the power across the

asked by ong on July 24, 2010
5. ### physhcs

An A.c circuit consist of 3uf capacitor and 500ohm resistor in series. If the current voltage applied is 12v and frequency 50Hz. Calculate 1. Current through the circuit 2. Voltage accross the capacitor 3 phase angle 4. Average

asked by ogunleye seun on July 17, 2013
6. ### physics/science

An A.c circuit consist of 3uf capacitor and 500ohm resistor in series. If the current voltage applied is 12v and and frequency 50Hz. Calculate 1. Current though the circuit 2. Voltage accross the capacitor 3 phase angle 4 average

asked by ogunleye seun on July 17, 2013

What is the (a) maximum and (b) minimum total resistance value that can be obtained using three resistors whose values are 2.0 ohms, 4.0ohms and 6.0 ohms? The resistors can be used individually, in pairs, or all three at once. Is

asked by samantha on November 25, 2012
8. ### science

If a 12V battery supplies an electric current of 13A, how do I work a the power supplied? resistance = R = E/I = 12v/13A Then Power = P = I2R help with regents exam tring to find out about consumer,and energy vs

asked by sarah on January 17, 2007
9. ### help

If you know the power rating of an appliance and the voltage of the line it is attached to, you can calculate the current the appliance uses by A. multiplying the voltage by the power. B. subtracting the power from the voltage. C.

asked by sid on October 20, 2015
10. ### Electricity

in the circuit below find the volts at V4 4 is grounded R1 is 15 volts R2 is 12 volts R3 is 10 volts www.ibiblio.org/kuphaldt/electricCircuits/DC/00082.png my answer is 15v+12v+10v =37v if V1=37v, then v2=37v-15v = 22v, then

asked by anonymous on April 14, 2019

More Similar Questions