Physics ib

posted by .

What is the way to set up an electric circuit with a filament lamp, switch, battery, ohmmeter, voltmeter and variable resistor as to have the most optimal measurement for the current and voltage?

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. SCIENCE

    Car headlight circuit - is this possible or do I need two separate circuit diagrams?
  2. Physics

    A 12 V battery is connected to 5 mega ohm resistor and a 6 micro farad capacitor and an open switch. After how many seconds will the voltage across the resistor reach 9 V?
  3. physics

    which one of the following statements concerning an ac circuit is true?
  4. Physics

    Could someone please tell me what equations i am suppose to use to work out these problems. A capacitor in RC circuit has two overlapping plates of width 3.40 m and length 8.90 m separated by 2.60 cm. A dielectric of dielectric constant …
  5. physics.

    resistors of 30 ohms and 60 ohms are connected in parallel and joined in series to a 10 ohm resistor. the circuit voltage is 180 volts I need to find 1)the voltage of the parallel circuit 2)the resistance of the complete circuit 3)the …
  6. Physics 112

    A battery is connected in series with a R = 0.26 Ω resistor and an inductor, as shown in the figure below. The switch is closed at t = 0. The time constant of the circuit is τ = 0.10 s, and the maximum current in the circuit …
  7. Physics

    A 15.0 kΩ resistor is hooked up to a 45.0 V battery in a circuit with a switch. a.) What is the current flowing through the resistor?
  8. electromagnetism

    A series RLC circuit is connected to a a DC battery via a switch. #11A (3 points possible) A long time after the switch is closed, what is the current in the circuit?
  9. Physics

    a)In the series circuits, what do you notice about the voltage across each resistor compared with the voltage of the battery?
  10. electronics and circuits

    A battery in combination with a dependent current source is connected to a lamp in the circuit shown below in Figure 6-1. The battery is modeled as a voltage source in series with a resistor, Rbat, and has an open circuit voltage of …

More Similar Questions