physics

posted by .

Q. A 200 kg load is suspended by a cable from a crane . Two
ropes are attached to the load , acting at 90 deg to each
other. One rope exerts a pull of 220 N , at 10 deg below
horizontal, the other rope exerts a force of 360 N at 15 deg
below horizontal.
Calculate 1)tension in cable
2)angle of the cable to vertical.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Physics

    Two dogs pull horizontally on ropes attached to a post; the angle problem 1 between the ropes is 60.0 degrees. If dog A exerts a force of 270N and dog B exerts a force of 300N find the magnitude of the resultant force and the angle …
  2. physics

    A 25 ft long crane supported at its lower end by a pin is elevated by a horizontal cable. A 250 lb load is suspended from the outer end of the crane. The center of gravity of the crane is 10 ft from the pin and the crane weighs 200 …
  3. physics

    a giant crane was tested by lifting 2.232*10^6 kg load.find the magnitude of the force needed to lift the load with a net acceleration of 0m/s^2. if the same force is applied to pull the load up a smooth slope that makes 30 degrees …
  4. physics

    a giant crane was tested by lifting 2.232*10^6 kg load.find the magnitude of the force needed to lift the load with a net acceleration of 0m/s^2. if the same force is applied to pull the load up a smooth slope that makes 30 degrees …
  5. Physics

    A 285-kg load is lifted 22.0 m vertically with an acceleration a=0.170 g by a single cable. Determine the tension in the cable. (N) Determine the net work done on the load. (J) Determine the work done by the cable on the load. Determine …
  6. PHysics

    A 250 kg load is lifted 23 m vertically with an acceleration a = 0.185g by a single cable Determine the tension of the cable. =2900N Determine the net work done on the load. =?
  7. Physics

    The arm of a crane at a construction site is 13.1 m long, and it makes an angle of 20° with the horizontal. Assume that the maximum load the crane can handle is limited by the amount of torque the load produces at the base of the …
  8. Physics

    After an unfortunate accident at a local warehouse you have been contracted to determine the cause. A jib crane collapsed and injured a worker. The horizontal steel beam had a mass of 88.50 kg per meter of length and the tension in …
  9. Physics

    A 345N load is suspended from a cable. What is the acceleration of the load if the tension in the cable is 275N£¿
  10. PHYSICS

    can someone help me with physics lab homework please: load 300 g at 60 degree mass at 180 deg 150 g mass at 270 deg 260 g for step two resolution of 300-g at 60 degree f load= fx'= fy'= percent error for each component for setup II?

More Similar Questions