physical

posted by .

Rank the following 3 classes of materials in order of increasing typical Young's Modulus: metals such as copper, plastics such as HDPE (high density polyethelene), and ceramics such as alumina (Al2O3). Do not look up the values of Young's Modulus, instead base your answer on what you know about the structure and chemistry of these classes of materials.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. computer science(Algorithm)

    An m X n YOUNG TABLEAU is an m X n matrix such that the entries of each row are in sorted order from left to right and the entries of each column are in sorted order from top to bottom. Some of the entries of YOUNG TABLEAU maybe ¡Þ, …
  2. Physics

    small cube of copper (density = 8930 kg/m3) is used to support a large cube of marble (density = 2560 kg/m3). The copper cube has sides of length 2.00 cm and is carefully placed on a flat, level table under the center of the cube of …
  3. Chemistry

    H6P7: Young's Modulus Rank the following 3 classes of materials in order of increasing typical Young's Modulus: metals such as copper, plastics such as HDPE (high density polyethelene), and ceramics such as alumina (Al2O3). Do not …
  4. Chemistry

    Rank the following three elements in order of increasing Young'sModulus: Ge, Sn, Si. My answer is as follows: Sn<Ge<Si. I am not sure if this correct. Can someone verify. Thanks.
  5. Material Sciences

    A unidriectional, continuously reinforced glass fiber composite has Vf=60 volume percent fibers in a matrix of epoxy. Glass has a Young's Modulus of Eglass=70GPa; epoxy has a Young's Modulus of Eepoxy=2GPa (a) Give numerical values …
  6. Material Sciences

    The molar crosslink density of a rubber is measured to be 468mol/m3 for a temperature T=300K. What is the Young's modulus of the rubber in MPa?
  7. Materials Science

    Aluminum is a cubic crystal, with S11=1.59×10−11 m2/N S12=−0.58×10−11 m2/N S44=3.52×10−11 m2/N What are the Young's modulus, Poisson's ratio and shear modulus, corresponding to these values?
  8. physics

    A copper (Young's modulus 1.1 x 1011 N/m2) cylinder and a brass (Young's modulus 9.0 x 1010 N/m2) cylinder are stacked end to end, as in the drawing. Each cylinder has a radius of 0.14 cm. A compressive force of F = 4800 N is applied …
  9. Creating High-Quality Centers

    Which of the following statements accurately reflects what we know about facilitating science learning for infants and toddlers?
  10. Statics

    Compare the Young's modulus E∗ of two open-cell foams. Which Young's modulus is higher?

More Similar Questions