chemistry

posted by .

Assume that 50ml of 0.01M edta solution were added to 25ml of co solution and the excess edta required 20ml of 0.005M mg solution. Calculate ppm co+ present.

The answer 942ppm

Bob helps me

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Chemistry

    A 25.00 ml sample of a standard solution containing 1 g of CaCO3/L required 25.20 ml of EDTA to fully complex the Ca present. Calculate the volume of EDTA stoichiometrically equivalent to 1.0 mg of CaCO3. From the volume of EDTA required …
  2. Chemistry

    The reaction of a metal ion, M^2+, with EDTA is given in the following equation: M^2+(aq) + Y^4-(aq) <==> MY^2-(aq) The EDTA was standardized with a 0.04 M Zn^2+ solution. 25.05 mL of EDTA solution was used to titrate the Zn^2+ …
  3. analytical chemistry

    An EDTA solution is standardized against a solution of primary standard CaCO3 (0.5622 g dissolve in 1000 ml of solution) and titrating aliquots of it with the EDTA. If a 25.00 ml aliquot required 21.88 ml of the EDTA, what is the concentration …
  4. chemistry

    0.5g of fuming h2s04 oleum is diluted with water. This solution is completely neutralized by 26.7ml of 0.4N naoh. Find the percentage of free s03 in the smaple solution. The answer 20.6% Assume that 50ml of 0.01M edta solution were …
  5. Analytical chemistry

    A 25.0-mL solution of 0.0660 M EDTA was added to a 33.0-mL sample containing an unknown concentration of V3 . All V3 present formed a complex, leaving excess EDTA in solution. This solution was back-titrated with a 0.0450 M Ga3 solution …
  6. analytical chemistry

    A solution containing both Fe 3+ and Al 3+ can be selectively analyzed for Fe 3+ by buffering to a pH of 2 and titrating with EDTA. Th e pH of the solution is then raised to 5 and an excess of EDTA added, resulting in the formation …
  7. Chemistry (titrations)

    15.00 mL of 0.01200 M EDTA were used to titrate 50 mL aliquot solution containing iron (II). How much iron (II) is present in the solution?
  8. Chemistry (Re-post)

    A solution contains 1.694 mg of CoSO4 (MW 155.0) per mL. Calculate a) The volume of 0.008640 M EDTA needed to titrate a 25.00 ml aliquot of this solution. So this is my working out for this section, Step 1. Moles of CoSO4 = 0.0001694mg …
  9. Chemistry

    A solution contains 1.694 mg of CoSO4 (MW 155.0) per mL. Calculate a) The volume of 0.008640 M EDTA needed to titrate a 25.00 ml aliquot of this solution. Step 1. 0.001694g * 25ml * 1/155 g/mol= 0.0002732 mol Step 2. Volume of EDTA …
  10. Chemistry

    You are titrating 50ml of a 0.02M solution of Zn^+2 at pH 7 with 0.05M solution of EDTA. What is the [Zn+2] after 20mL of EDTA has been added?

More Similar Questions