CHEMISTRY

posted by .

FOR MOST LABS THAT WE PERFORM , THE MEASURED WALUES ARE ALWAYS COMPARED TO THE ACCEPTED VALUES USUALLY IN THE FORM OF PERCANT ERROR . WHY IS THIS DONE?

  • CHEMISTRY -

    To provide some indication to you (and others) of how proficient you are at
    a. following directions
    b. manual dexterity
    c. drawing conclusions
    d. using lab procedures for measurements.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Chemistry (check)

    12) Relative error is also called _______ I got accepted value decimal error?
  2. Chem (Check)

    The accepted value of a length measurement is 200cm, and the experimental value is 198cm. Circle the letter of the value that shows the precent error of this measuerment. a)2% b)-2% c)1% d)-1% is it b)-2% No. What is 2/200 * 100?
  3. Chemistry

    How do you find Absolute error and how do you find relative error?
  4. Physics

    How do i do this ? ? ? : Suppose you have collected the data shown below for the circuit in Figure 1. Voltage is measured across the resistor. Current is measured through the resistor. The exact value of the resistor is 100 Ω.
  5. Percent error?

    What is the formula for percent-error? It's either: %error= (your value/accepted value)*100 or %error= (accepted value/your value)*100 I'm pretty sure it's the first one, but I also heard it can go either way. I tried both ways but
  6. calculus

    The volume V of a cylinder is computed using the values 9.8 \text{m} for the diameter and 3 \text{m} for the height. Use the linear approximation to estimate the maximum error in V if each of these values has a possible error of at …
  7. Chemistry

    The accepted value of a quantity is 4.70g. If the measured value is 4.98g what is the percent error?
  8. physics

    Compare the slope of the velocity-time graph to the average of all your acceleration values. Are they close?
  9. chemistry

    the accepted density of helium at stp is 0.18 g/L. during an expirement, 0.10g of helium with a volume of 0.54L at stp was collected. what is the percent error in this expirement?
  10. chemistry, physics

    What is the most important source of error in the calorimeter experiment?

More Similar Questions