posted by .

Which two types of steel appear to have their properties combined in tempered steel?

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Chemistry

    A 500kg steel boiler is used to convert 200kg of water into steam. Calculate the total energy required to heat both the steel and its' contents from 20.0°C to 100.0°C. The specific heat capacity of the steel is 0.528J/g°C. Heattotal= …
  2. Engineering

    5. Two pieces of steel are held together with six bolts. One end of the first piece of steel is welded to a beam and the second piece of steel is bolted to the first. There is a load of 54,000 pounds applied to the end of the second …
  3. Physics

    Steel is very stiff, and the Young's modulus for steel is unusually large, 2.0×1011 N/m2. A cube of steel 25 cm on a side supports a load of 85 kg that has the same horizontal cross section as the steel cube. What is the magnitude …
  4. physics

    A manufacturer wishes to produce crude benzene models for the chemistry department. The manufacturer plans to do this by punching regular hexagons out of steel. If the steel plate is 0.500 cm thick, What is the minimum shearing force …
  5. History, Social Studies

    People had known how to make steel since ancient times, but many historians claim steel caused a second industrial revolution at the end of the nineteenth century. Name the two innovators and the innovations in the production of steel …
  6. Chemistry

    Which two types of steel appear to have their properties combined in tempered steel?
  7. mechanics

    The change in length of a steel wire under an applied load can be halved by keeping all other conditions constant but using: A. a different material having a Young's modulus half that of steel B half the cross sectional area of the …
  8. chemistry

    Which 2 types of steel appeared to have their properties combined in tempered steel
  9. Physics -Material

    1. If you are designing a product with requirement of a high UTS(Ultimate tensile Strenght), high YS, low ductility steel, what process should you apply onto steel to get the steel with required properties?
  10. Physics

    In an inelastic collision, a steel ball of mass 200 g was hit hard into a large ball of dough of mass 700 g. The velocity of the steel ball was 25m/s. After the collision, the steel ball was stuck in the dough, and this combined system …

More Similar Questions