Post a New Question

IT

posted by .

Can someone please help me start this?

Using Shannon’s formula, calculate the data transfer rate given the following information:

signal frequency = 10,000 Hz
signal power = 5000 watts
noise power =230 watts.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. PreCalc

    The decibel (dB) is defined as dB= 10log (P2/P1), where P2 is the power of a particular signal. P1 is the power of some reference signal. In the case of sounds, the reference signal is a sound level that is just barely audible.How …
  2. math

    if 1790 maga watts of power,out of 3000 mega watts generated by a power utility, reach the destination, what percentage of the generated power reaches its destination. please show work
  3. Math Max min problems

    The power P delivered to a load by a current of i amperes through a resistance of 19 ohms, when 110 volts are supplied at one end of the line, is given by the formula P = 110i - 19i2 . Determine the maximum power that can be delivered. …
  4. Physics

    George pushes a wheelbarrow for a distance of 12 meters at a constant speed for 35 seconds by applying a force of 20 newtons. What is the power applied to push this wheelbarrow?
  5. science

    A linear circuit is shown below in Figure 1. Figure 1 The elements in this circuit have the following values: R1=100Ω, R2=200Ω, R3=350Ω, V=5V, and I=0.004A. Determine the potentials drops vA and vB across resistors R1 …
  6. Telecommunications

    If a Signal with a power level of 40 mW is inserted onto a transmission line and the measured power some distance away is 10 mW, calculate the loss of signal strength is decibels.
  7. Geophysics

    A continuous signal is sampled at regular intervals, every 10 ms. What is the maximum frequency that can be captured by this sampling process without incurring any distortion of the original signal?
  8. Algebra

    The power P (in watts) generated by a windmill that has efficiency E is given by the formula P = 0.31ED^2V^3, where D is the diameter (in feet) of the windmill blades and V is the wind velocity (in ft/sec). Approximate the wind velocity …
  9. computer science

    A GPS satellite develops a fault whereby it moves into an orbit 19 500 km above the Earth’s surface and also emits a weak signal whose power is only 24 W. What will be the power per square metre of the signal received on the Earth’s …
  10. Science

    A current of 6.0 amps passes through a motor that has a resistance of 5.0 ohms. Calculate the power 30 watts 150 watts 180 watts *** 900 watts Thanks

More Similar Questions

Post a New Question