Physics

posted by .

A bucket is filled with a combination of water (density 1,000 kg/m3) and oil (density 700 kg/m3). These fluids do not mix. (The oil will float on top of the water.) If the layer of oil is 63 cm tall, what is the pressure at the interface between the oil and the water?

  • Physics -

    H(oil)*g*(oil density) + Po
    = 0.63*9.8*700 + Po
    = 4.32*10^3 N/m^2 + Po

    Po is atmospheric pressure. At sea level, it is about 1.013*10^5 N/m^2

    Po must be added to the pressure that is due to the height of the oil column

  • Physics -

    oil is a thick layer which is not disolve

  • Physics -

    tail ty khan wasty istmal honda tu uno pani wivch zaya krna wy amb lena

  • Physics -

    because oil is lighter than water

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Physics - Fluids

    A cube of side length 11.0 cm and made of unknown material floats at the surface between water and oil. The oil has a density of 810 kg/m^3. a)If the cube floats so that it is 70% in the water and 30% in the oil, what is the mass of …
  2. Physics

    A U-shaped tube is filled mostly with water, but some vegetable oil has been added to both sides of the U tube. On the right side of the tube, the depth of oil is 5.00 cm . On the left side of the tube, the depth of the oil is 2.30cm …
  3. Physics- PLEASE!!

    A U-shaped tube is filled mostly with water, but some vegetable oil has been added to both sides of the U tube. On the right side of the tube, the depth of oil is 5.00 cm . On the left side of the tube, the depth of the oil is 2.30 …
  4. PHYS101

    oil is added to the right hand arm of a U-tube containing water.The oil floats above the water to a height of h=10cm.The top of the oil+water column is a height d=2cm above the top of the water column in the other arm .Calculate the …
  5. physics

    Four tubes are set up in the lab at sea level as shown by the figure. The letter under each tube corresponds the question with the same letter. 1 atm = 101300 Pa = 101300 N/m2 ρwater = 1000 kg/m3 (a) What is the pressure pushing …
  6. science

    a u-tube is partially filled with water.oil which does not mix with water is next poured into one side until water rises by 2.5cm on the other side.if the density of oil be 0.8 ,the oil level will stand higher than the water level …
  7. Physics

    Suppose you pour water into a container until it reaches a depth of 12 cm. Next, you pour in a 25-cm-thick layer of oil so that it floats on top of the water. The density of the oil is 0.92 g/cm3 and that of water is 1.00 g/cm3. What …
  8. Physics

    A cubical block of wood 0.100 m on a side and with a density 550 kg/m^3 of floats in a jar of water. Oil with a density of 750 kg/m^3 is poured on the water until the top of the oil layer is 0.035 m below the top of the block. 1. How …
  9. Physics

    an open tank contains a layer of oil floating on top of a layer of water (of density 1000 kg/m3) that is 3.0 m thick, as shown. What must be the thickness of the oil layer if the gauge pressure at the bottom of the tank is to be 9.1×104 …
  10. Physics

    In a huge oil tanker, salt water has flooded an oil tank to a depth of h2 = 4.50 m. On top of the water is a layer of oil h1 = 7.55 m deep, as in the cross-sectional view of the tank as shown in the figure. The oil has a density of …

More Similar Questions