Engineering

posted by .

What is the upper tripper point (UTP) of a comparator with hysteresis if R1 = 47 kÙ, R2 = 68 kÙ and the maximum positive output voltage is 10V?

  • Engineering -

    Hys. = (Vomax/(R1+R2))R1.
    Hys. = (10/(47k+68k))47k = 4.09 Volts.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Engineering

    Designation of clamper circuit: Input Square Wave is described as follow: V max : 20V V min : -15v Frequency : 10kHz Design a clamper circuit to shift its referecence point so that its reference point is -10V. Specify all component …
  2. Physics

    #1.) A solar photovoltaic panel has an area of 3 m^2. The panel's maximum power output is 595 W @ 1100 W/m^2. a) What is its efficiency?
  3. Physics

    #1.) A solar photovoltaic panel has an area of 3 m^2. The panel's maximum power output is 595 W @ 1100 W/m^2. a) What is its efficiency?
  4. Physics

    What is the upper tripper point (UTP) of a comparator with hysteresis if R1 = 47 kÙ, R2 = 68 kÙ and the maximum positive output voltage is 10V?
  5. Engineering

    A certain OTA with a transconductance of 5000 µS has a load resistance of 10 kÙ. If the input voltage is 100 mV, what is the output current?
  6. Amplifiers

    An op amp has a maximum output voltage swing of 10 Vpp and a voltage gain of 100. What is the largest peak to peak input signal that can be applied to the input without clipping the output signal?
  7. Physics

    Design an AC circuit with R, L, and C components so that it can achieve output voltage in a given load to be doubled in amplitude (magnitude) while achieving increase in the phase shift of the output voltage of 45 more than the phase …
  8. Physics

    Posting this question again Design an AC circuit with R, L, and C components so that it can achieve output voltage in a given load to be doubled in amplitude (magnitude) while achieving increase in the phase shift of the output voltage …
  9. PHYSICS

    The rms output voltage of an AC source is 210 V, and the operating frequency is 90 Hz. Write the equation giving the output voltage as a function of time t.
  10. Physics

    The following circuits represent a logarithm amplifier The output voltage for a log amp with a diode can be determined by the formula below Vout = -(.025V)ln(Vin/IR*R1) , the ln is the natural logarithm of a number. Calculate in a …

More Similar Questions