strength of mechanics

posted by .

Determine the midspan value of EI(shear stress) for the beam w/c carries a uniformly varying load over part of the span.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. solid mechanics 1

    a load p is supported by a steel pin that has been inserted in a short wooden member hanging from the ceiling. the ultimate strength of the wood used is 60 MPa in tension and 7.5 MPa in shear, while the ultimate strength of the steel …
  2. Solid Mechanics

    A cast iron block of 5Cm^2 cross section carries an axial compressive load of 50KN.Calculate the magnitude or normal and shear stresses on a plane whose normal is inclined at 30 deg.to the axis of the block,also determine the maximum …
  3. statics

    A cantilever beam member made from steel with hollow circular cross section experiences an axial load of 300 KN (F1), and a vertical load of 200 kN (F2) as shown in the following figure. The outside diameter of the beam is 50mm and …
  4. Solid Mechanics

    A casts iron block of 5cm2 cross section carries load of 50KN. Calculate the magnitude or normal and shear stresses on a plane whose normal is inclined at 30o to the axis of the block. Also determine the maximum shear stress in the …
  5. Solid Mechanics

    pls help me to resolve this question A casts iron block of 5cm2 cross section carries an axial load of 50KN. Calculate the magnitude or normal and shear stresses on a plane whose normal is inclined at 30o to the axis of the block. …
  6. mechanics of materials

    A steel bar with a cross sectional area of 25cm2 is found to shear fracture when subjected to a tensile load of 400kN. calculate the limiting shear stress of the bar.
  7. mechanics of materials

    A steel bar with a cross sectional area of 25cm2 is found to shear fracture when subjected to a tensile load of 400kN. calculate the limiting shear stress of the bar.
  8. Physics/Mechanics

    HW8_1: CANTILEVERED BEAM WITH TAPERED SQUARE CROSS SECTION A cantilevered beam of length L has a square cross section of side length linearly varying from hA at the free end to hB=3hA, at the fixed support. A concentrated load, P, …
  9. Materials Science

    A 3-point bending test is performed on a simply supported beam of length L=4m and of rectangular cross-section, with width b and height h. For a central load of 10kN, draw the bending moment and shear force diagrams for the beam. Then …
  10. Materials Science

    A hollow cylinder with outer radius r0 and inner radius ri is loaded by a uniformly distributed load q across its length L. The beam is supported by a roller at its left end and a pin L5 from its right end. What is the maximum bending …

More Similar Questions