Chemistry-help

posted by .

0.5g of Solid A is dissolved in 1L solvent to give a concentration of concentration 0.5g/L.
UV absorbance spectrum was collected.
How to calculate the absorptivity on the dried basis?

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. chemistry

    The standard solution of FeSCN2+ (prepared by combining 9.00 mL of 0.200 M Fe(NO3)3 w/1.00 mL of 0.0020 M KSCN) has an absorbance of 0.510. If a trial's absorbance is measured to be 0.250 and its initial concentration of SCN– was …
  2. Chemistry

    Ca(IO3)2(s) ⇌ Ca^(2+)(aq) + 2IO3^(-)(aq) First, you poured 30 mL of 0.100 M Ca^(2+) solution over a 2.000 g sample of solid Ca(IO3)2 and allowed the mixture to sit for 30 minutes. Some of the solid dissolved, causing the calcium …
  3. Chemistry

    In the experiment shown below, you add some salt to water. A = All of the solid dissolves (no solid at the bottom). B = You add more water and the solid stays dissolved. Select all of the following that are true about solutions A and …
  4. Chemistry

    A solution of transferrin exhibits an absorbance of 0.463 at 470 nm in a 1.000-cm cell. Calculate the concentration of transferrin in mg/mL and the concentration of bound iron in μg/mL. At wavelength 428(nm), molar absorptivity …
  5. Chemistry

    Transferrin (T) - Molar mass = 81000g/mol - carries 2 Fe3+ ions Deferrioxxamine B (DB) molar mass = 650g/mol - carries 1 Fe3+ at wavelength 428 molar absorptivity T = 3240 molar absorptivity DB = 2630 at wavelength 470 molar absorptivity …
  6. Chemistry

    Calculate the concentration of bromocresol green (BG) indicator It says that Molar absorptivity = Absorbance at a wavelength/ concentration of BG indicator I am having trouble calculating the concentration of BG. Other info: Stock …
  7. chemistry

    1. A sample weighing 1.30 mg was analyzed to determine the concentration of a certain compound (FW =292.16 g/mol) using UV/Visible spectrometry. First, the sample was dissolved in 5.00 mL volumetric flask. A 1.00 mL aliquot was drawn …
  8. ANALYTICAL CHEMISTRY

    A sample weighing 1.25 mg containing a certain compound M (FW 292.16 g/mol) was dissolved in solvent in a 5.00 mL volumetric flask. A 1.00 mL aliquot was drawn up, placed in a 10.00 mL volumetric and diluted to the mark with solvent. …
  9. Chem

    If you have an equation for a line, y = 0.15x + 0.010, where y is absorbance and x is concentration in molarity of Fe (2+), calculate the concentration of a test sample with an absorbance of 0.065. What is the absorbance value for …
  10. CHEM

    How is molar absorptivity used to determine concentration from absorbance?

More Similar Questions