Science
posted by Sasee .
How to calculate the height of water column gushing that would be gushing out from a 100 mm diameter pipe opening if the velocity of the water flowing through the pipe is 1.6 meters / second.
Respond to this Question
Similar Questions

Physics
The water flowing through a 1.9 cm (inside diameter) pipe flows out through three 1.3 cm pipes. (a) If the flow rates in the three smaller pipes are 24, 18, and 13 L/min, what is the flow rate in the 1.9 cm pipe? 
physic
you need to extend a 2.50 inch diameter pipe, but you only have 1.00 inch diameter pipe on hand.you make a fitting to connect these pipes end to end. if the water is flowing at 6.00cm/s in the wide pipe, how fast will it be flowing … 
physics
A horizontal pipe 17.00 cm in diameter has a smooth reduction to a pipe 8.50 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water … 
Physics
Water is flowing in a pipe with a varying crosssection area, and at all points the water completely fills the pipe. At point 1 the crosssection area of the pipe is 0.080 m^2, and the magnitude of the fluid velocity is 2.50m/s. Calculate … 
Physics
Water is flowing through a pipe (area 4.0 cm2) that connects to a faucet adjusted to have an opening of 0.57 cm2. If the water is flowing at a speed of 5.3 m/s in the pipe, how long does it take for water from the faucet to fill a … 
Math  Calculus
Water is flowing in a cylindrical pipe of radius 1 inch. Because water is viscous and sticks to the pipe, the rate of flow varies with distance from the center. The speed of the water at distance r inches from the center is 10(1(r^2)) … 
Fluid Mechanics
Water flows into a cylindrical tank through pipe 1 at a rate of 25 ft/s and leaves through pipe 2 at 10 ft/s and through pipe 3 at 12 ft/s. Pipe 4 is an open air vent. Internal diameters of the pipes are: D1=3 in, D2= 2 in, D3=2.5 … 
Dimensionless parameters
The drag, D, on a sphere located in a pipe flow through which a fluid is flowing to be determined experimentally. Assume that drag is a function of the sphere diameter, d, the pipe dianeter, H, the fluid velocity, V, and the fluid … 
math
Water flows through a pipe with the inner diameter of 20cm at a speed of 1m/s. How long does it take for the water flowing out from the pipe to fill a cylindrical tank with the base radius of 0.8m and the height of 0.5m? 
PHYSICS
Water flowing out of a horizontal pipe emerges through a nozzle. The radius of the pipe is 1.5 cm, and the radius of the nozzle is 0.42 cm. The speed of the water in the pipe is 0.68 m/s. Treat the water as an ideal fluid, and determine …