physics

posted by .

starting from rest s=0,pulley A (rA=50 mm)is given a constant angular acceleration, A=6 rad/s2. Pulley C(rC=150mm) has an inner hub D (rD=75 mm) which is fixed to C and turns with it. What is the speed of block B when it has risen s=6 m ?

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Physics, please help me today.

    four pulleys are connected by two belts. Pulley A (radius 15cm) is the drive pulley and it rotates at 10 rad/s. Pulley B (radius 10 cm) is connected by belt 1 to pulley A. Pulley B' (radius 5cm) is concentric with pulley B and is rigidly …
  2. physics

    A block (mass = 2.9 kg) is hanging from a massless cord that is wrapped around a pulley (moment of inertia = 1.2 x 10-3 kg·m2), as the figure shows. Initially the pulley is prevented from rotating and the block is stationary. Then, …
  3. physics

    A pulley rotating in the counterclockwise direction is attached to a mass suspended from a string. The mass causes the pulley's angular velocity to decrease with a constant angular acceleration α = -2.2 rad/s2. If the pulley's …
  4. physics

    A 4.0 kg pulley of radius 0.15 m is pivoted about an axis through its center. What constant torque is required for the pulley to reach an angular speed of 25 rad/s after rotating 6.0 revolutions, starting from rest?
  5. physics

    A 4.0 kg pulley of radius 0.15 m is pivoted about an axis through its center. What constant torque is required for the pulley to reach an angular speed of 25 rad/s after rotating 6.0 revolutions, starting from rest?
  6. Physics please help! check if its correct

    A 3.00 kg stone is tied to a thin, light wire wrapped around the outer edge of the uniform 8.00 kg cylindrical pulley. The inner diameter of the pulley is 60.0 cm, while the outer diameter is 1.00 m. The system is released from rest, …
  7. math

    the constant angular acceleration of pulley is 4rad/s2, angular speed 3 rad/s, determine the radius of pulley if the total acceleration of a print on the rim of the pulley is 3.5m/s2
  8. dynamics

    13. The constant angular acceleration of a pulley is 4 rad/s2 and its angular speed its 3 rad/s. Determine the radius of the pulley if the total acceleration of a print on the rim of the pulley is 3.5m/s2.
  9. Physics

    A dentist causes the bit of a high-speed drill to accelerate from an angular speed of 1.20x10^4 rad/s to an angular speed of 3.14x10^4 rad/s. In the process, the bit turns through 1.92x10^4 rad. Assuming a constant angular acceleration, …
  10. Physic

    A block (mass 2.4 kg) is hanging from a massless cord that is wrapped around a pulley -3 2 (moment of inertia of the pulley = 1.3 x 10 kg·m ), as the drawing shows. Initially the pulley is prevented from rotating and the block is …

More Similar Questions