physics

posted by .

A .5 m long, 3 cm diameter metal bar has a Young’s Modulus of 7.0x1010 N/m2. If a 50,000 N force is applied to the end of the bar, by how much will it compress?

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. physics

    A light rigid bar is suspended horizontally from two vertical wires, one of steel and one of brass. Each wire is 2.00m long. The diameter of the steel wire is 0.60mm and the length of the bar AB is 0.20m. When a mass of 10.0kg is suspended …
  2. physics

    A light rigid bar is suspended horizontally from two vertical wires, one of steel and one of brass. Each wire is 2.00m long. The diameter of the steel wire is 0.60mm and the length of the bar AB is 0.20m. When a mass of 10.0kg is suspended …
  3. physics

    a uniform bar of mass is supported by support pivoted at top about which bar can swing like simple pendulum. If force F is applied perpendicular to lower end of the bar.How big F must be in order to held the bar in equilibrium.
  4. Physics

    Tapered bar with end load The small tapered bar BC has length L=0.1 m and is made of a homogeneous material with Young’s modulus E=10 GPa. The cross sectional area of the bar is slowly varying between A0=160 mm^2 (at B) and A0/2 …
  5. physic

    The bar in the figure has constant cross sectional area A . The top half of the bar is made of material 1 with mass density ro1 , and Young’s modulus E1 . The bottom half of the bar is made of material 2 with density ro2 and …
  6. Physics

    The cylindrical bar in the figure has a total length L=1.2 m, a diameter d=15 mm, and is confined by fixed supports at the walls A and B. A concentrated axial load FC=30 kN is applied to the bar at point C as indicated in the figure, …
  7. solid mechanics

    A round bar 40 mm diameter was found to be 0.000775 mm. Find the Poisson's ratio and Young's Modulus for the material of the bar. Take value of shear modulus as 40 kN/mm square.
  8. Physics matter and its properties

    A bar is 500 mm long and is stretched to 505 mm with a force of 50 kN. The bar is 10 mm diameter. Calculate the stress and strain The material has remained within the elastic limit. Determine the modulus of elasticity.
  9. physics

    Bar AB has length L, constant thickness d, and a width that tapers linearly from 3d at its fixed end (A) to d at its free end (B; see the figure below). The bar is homogeneous with mass density ρ and Young's modulus E. When hung …
  10. Physics

    An aluminum (with Young's modulus 7 x 10^10 Pa) rail is 88.0 m long and has cross-sectional area 0.00050 m^2. The rail is fixed at one end and a 4000 N force is applied at the other end. By how much does the bar stretch?

More Similar Questions