Chemistry

posted by .

if some volatile impurities in the crucible are not burned off in step 1 but are removed in step 4 is the reported percent mass of water in the hydrated salt too high or too low?

  • Chemistry -

    too high

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Chemistry

    If some volatile impurities in the crucible are removed from the hydrated MgSO4 along with the water, is the reported mass of water removed too high or too low. Explain.
  2. Chemistry

    What happens to the sample's reported water content if the salt decomposes yielding a volatile product?
  3. maddy

    the crucible is not fired, as the procedure suggests, but had retained some impurities from previous use(or it could be oily smudges from fingers). the mass of the "dirty" crucible is recorded. however the impurities are burned off …
  4. Chemistry

    A 2.914 gram sample of gypsum, a hydrated salt of calcium sulfat, CaSO4, is heated at a temperature greater than 170 degrees Celcius in a crucible until a constant mass is reached. The mass of the anhydrous CaSO4 salt is 2.304 grams. …
  5. Chem Lab

    I did a chem lab and have to figure out some stuff off of some data I found during the lab Weight of empty crucible and cover: 19.74 g Weight of crucible, cover and hydrated salt: 22.74 g Weight of crucible, cover and hydrated salt …
  6. Chem Lab

    I did a chem lab and have to figure out some stuff off of some data I found during the lab Weight of empty crucible and cover: 19.74 g Weight of crucible, cover and hydrated salt: 22.74 g Weight of crucible, cover and hydrated salt …
  7. Chem

    The crucible is handled with oily fingers after its mass measurement but before the 3 gram sample of the hydrated salt is measured. Subsequently, in part B.1, the oil from the fingers is burned off. Will the percent water in the hydrated …
  8. CHEMISTRY

    I also need help in this please: Suppose the original sample is unknowingly contaminated with a second anhydrous salt. Will the reported percent water in the hydrated salt be too high, too low, or unaffected by its presence?
  9. CHEMISTRY

    is this right? 5. After heating the crucible is set on the lab bench where it is contaminated with the cleaning oil used to clean the lab bench but before its mass is measured. The analysis continues where the mass of the anhydrous
  10. chem

    The crucible is handled with oily fingers after its mass measurement but before the 3 gram sample of the hydrated salt is measured. Subsequently, in part B.1, the oil from the fingers is burned off. Will the percent water in the hydrated …

More Similar Questions