physics

posted by .

A rope goes over a circular pulley with a radius of 6.3 cm. If the pulley makes four revolutions without the rope slipping, what length of rope passes over the pulley?

  • physics -

    Four pulley circumferences
    = 4 * (2 pi R) = 8 pi R

    Plug in the numbers.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Physics

    You pull downward with a force of 27 N on a rope that passes over a disk-shaped pulley of mass 1.3 kg and radius 0.075 m. The other end of the rope is attached to a 0.61 kg mass. Find the tension in the rope on both sides of the pulley. …
  2. physics help pleease!!

    A rope goes over a circular pulley with a radius of 6.3 cm. If the pulley makes four revolutions without the rope slipping, what length of rope passes over the pulley?
  3. Physics

    A special pulley has two discs with radii R1 = .8 m and R2 = .35 m. A rope from the R2 disc connects the pulley to a wall and a rope from the R1 disc connects the pulley to a hanging mass. The axle is frictionless. The total mass of …
  4. Physics

    A pulley system os being used to raise a load. The rope begins at the ceilings, goes down, round a pulley on the load, up to a pulley on the ceiling, back down and around a second pulley on the load, and up to a sheave (a motor driven …
  5. physics

    A 3 lb bucket containing 40 lb of water is hanging at the end of a 20 ft rope that weighs 4 oz/ft. The other end of the rope is attached to a pulley. How much work is required to wind the length of rope into the pulley, assuming that …
  6. Physics

    A 59-kg housepainter stands on a 16-kg aluminum platform. The platform is attached to a rope that passes through an overhead pulley, which allows the painter to raise herself and the platform. (Ignore the mass of the pulley and any …
  7. Physics

    A rope goes over a circular pulley with a radius of 5.5 If the pulley makes 6 revolutions without the rope slipping, what length of rope passes over the pulley?
  8. college physics

    an atwood machine is constructed by mounting a well-lubricated pulley (not necessarily a ring/disc), whose radius is 6.00cm on an axle and passing a rope over the pulley. Each end of the rope is attached to a different mass of 3.0 …
  9. physics

    Consider the system shown in the diagram. The pulley is a uniform cylinder with mass m3 = 0.60 kg and radius R = 4.0 cm, the other two masses are m1 = 2.5 kg and m2 = 1.0 kg, and รก = 30o. Assume the rope is massless, there is no slipping …
  10. Physics

    the coefficient of kinetic friction between both blocks and the table is .200. determine the accelerations of blocks A and B each of which has a mass of 5.0kg The diagram shows a table with two blocks labeled A and B on them. A is …

More Similar Questions