physics help pleease!!

posted by .

A rope goes over a circular pulley with a radius of 6.3 cm. If the pulley makes four revolutions without the rope slipping, what length of rope passes over the pulley?

how can i find distance if the only variable given is radius and revolutions?

  • physics help pleease!! -

    Arc length = radius * angle (in radians)

    In this case, arc length equals length of rope, so

    L = r*θ = 6.3*4(2π)

    Can you take it from here?

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Physics

    You pull downward with a force of 27 N on a rope that passes over a disk-shaped pulley of mass 1.3 kg and radius 0.075 m. The other end of the rope is attached to a 0.61 kg mass. Find the tension in the rope on both sides of the pulley. …
  2. physics

    A rope goes over a circular pulley with a radius of 6.3 cm. If the pulley makes four revolutions without the rope slipping, what length of rope passes over the pulley?
  3. science

    In the system shown in the figure , block A has mass m_A = 2.08 kg, block B has mass m_B = 0.370 kg, and the rope connecting them has a nonzero mass 0.203 kg. The rope has a total length 1.03 m and the pulley has a very small radius. …
  4. Physics

    A special pulley has two discs with radii R1 = .8 m and R2 = .35 m. A rope from the R2 disc connects the pulley to a wall and a rope from the R1 disc connects the pulley to a hanging mass. The axle is frictionless. The total mass of …
  5. Physics

    A pulley system os being used to raise a load. The rope begins at the ceilings, goes down, round a pulley on the load, up to a pulley on the ceiling, back down and around a second pulley on the load, and up to a sheave (a motor driven …
  6. physics

    A 3 lb bucket containing 40 lb of water is hanging at the end of a 20 ft rope that weighs 4 oz/ft. The other end of the rope is attached to a pulley. How much work is required to wind the length of rope into the pulley, assuming that …
  7. Physics

    A rope goes over a circular pulley with a radius of 5.5 If the pulley makes 6 revolutions without the rope slipping, what length of rope passes over the pulley?
  8. college physics

    an atwood machine is constructed by mounting a well-lubricated pulley (not necessarily a ring/disc), whose radius is 6.00cm on an axle and passing a rope over the pulley. Each end of the rope is attached to a different mass of 3.0 …
  9. physics

    Consider the system shown in the diagram. The pulley is a uniform cylinder with mass m3 = 0.60 kg and radius R = 4.0 cm, the other two masses are m1 = 2.5 kg and m2 = 1.0 kg, and รก = 30o. Assume the rope is massless, there is no slipping …
  10. Physics

    the coefficient of kinetic friction between both blocks and the table is .200. determine the accelerations of blocks A and B each of which has a mass of 5.0kg The diagram shows a table with two blocks labeled A and B on them. A is …

More Similar Questions