Chemistry

posted by .

The Question Is:

"A student weighs 0.347 g of KHP on a laboratory balance. The KHP was titrated with NaOH and the concentration of the NaOH determined to be 0.110 M. For the second titration, the student correctly diluted 6 M HCl from the reagent shelf using a graduated cylinder to obtain approximately 0.6 M HCl. This solution was titrated with the original NaOH solution. The student calculated the concentration of NaOH from the experiment to be 0.099 M. In which experiment should the student be more confident of the concentration of the NaOH solution? Why?"

I believe the second titration would be more accurate due to it being titrated with the original amount of NaOH and so im assuming that its concentration would yield a better result. Would that be the case, is there anything im neglecting?

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. chemistry

    If the stockroom fails to dry the KHP to remove the waters of hydration, the student's calculated concentration for the standardized base will be: ____________ (low, high, or unaffected) A drop of NaOH is hanging from the buret tip …
  2. chemistry

    KHP is a monoprotic acid with a molar mass of 204.22 g/mol. The titration data are as following. The average concentration of NaOH solution is M. 1 2 3 mass of KHP (g) 2.789 2.543 2.612 vol NaOH used (mL) 27.77 23.22 27.12 You didn't …
  3. College Chemistry

    The Question Is: "A student weighs 0.347 g of KHP on a laboratory balance. The KHP was titrated with NaOH and the concentration of the NaOH determined to be 0.110 M. For the second titration, the student correctly diluted 6 M HCl from …
  4. College Chemistry

    "A student weighs 0.347 g of KHP on a laboratory balance. The KHP was titrated with NaOH and the concentration of the NaOH determined to be 0.110 M. For the second titration, the student correctly diluted 6 M HCl from the reagent shelf …
  5. Chemistry

    A student titrated 1.852 g of a mixture containing potassium hydrogen phthalate, KHP....?
  6. Chemistry

    A Student Performing a lab weighed a 1.0993g sample, containing an unknown KHP, which required 18.06mL of 0.1879M NAOH to reach the phenolphtalein endpoint. a) How many moles of base were consumed by the KHP in this sample?
  7. chemistry

    how do i calculate the NaOH molarity from a titration of KHP and NaOH after preparing KHP to standardise NaOH. KHP mass was 2.0378g dissoveld in distilled water to fill up a 100ml volumetric flask and only 10ml of this solution was …
  8. chemistry

    Titration was used to determine the molarity of acetic acid in vinegar. A primary standard solution of KHP was used to standardize the NaOH. 1. When performing this experiment, impure KHP was used to standardize the NaOH solution. …
  9. Chemistry

    A standard KHP solution is made by dissolving 2.12 grams of KHP in 100.00 mL of water. The KHP solution is then titrated with NaOH solution. It takes 23.12 mL of NaOH to reach the endpoint. What is the concentration of the NaOH?
  10. Chemistry

    The student used the KHP in a subsequent titration experiment where he titrated 25.00 +/- 0.03 ml of the acid against an unknown solution of NaOH. The titration required 23.70 +/- 0.10 ml of the base. What is the concentration of NaOH?

More Similar Questions