# Organic Chem

posted by .

how would you make 300mL of toluene and hexane in a artion of 70:30 respectively?

• Organic Chem -

I can't read your question and make sense of it. This is how I interpret it. How to make a 70:30 mixture of toluene and hexane (and I assume that is volume:volume).
How about 70 mL toluene + 30 mL hexane (assume volumes are additive) = 100 mL so triple that to use
3*70=210 mL toluene
3*30=90 mL hexane.
If I didn't interpret the question properly, re-post and improve your typing skills (and be clearer, also).

## Similar Questions

1. ### science(chem)

Indicate the correct waste container for the following compounds choices are halogenated organic, nonhalogenated organic, aqueous, and organic solid a)hexane b)methylene chloride (dichloromethane) c)magnesium sulfate d)10% NaOH e)sodium …
2. ### Science (chem)

How would you make 300ml of a mixture of toluene and hexane in a ratio of 70:30 respectively?
3. ### Org. Chem.

1. Are the following soluble, insoluble, or partially soluble. - Benzophenone in hexane?
4. ### Organic Chemistry

Would it be possible to separate hexane (b.p. 68.95 degrees Celsius) from toluene (b.p. 110.6 degrees Celsius) by simple distillation?
5. ### organic chem

Calculate Percent Composition of the Unknown Mixture : Methanol BP 64.7 Toluene Bp 110.6
6. ### Organic CHM Lab

a) what is meant by the term flooding of the fractionating column and what causes it?
7. ### Chem Help

Assuming that no azetropes are formed, would it be easier to separate n-hexane and benzene or n-hexane and toluene by distillation?
8. ### Organic Chem Help :(

For each of the solvents below, indicate whether it will be the top or bottom layer when carrying out extraction of an aqueous layer of density 1.05 g/ml. a) chloroform (bottom layer) b) hexane =?
9. ### Organic Chem

Im not really sure how to begin with this question.. 1. The synthesis of toluene by the aluminum chloride-catalyzed Friedel-Crafts alkylation of benzene is badly complicated by the formation of di-, tri-, and polymethylated benzenes. …
10. ### chemistry

my developing solvent is hexane toluene acetic acid(5:5:1)nd my samples rf nd impurity rf is very close,my spots r not separating properly,so which hexane should hav to be used?

More Similar Questions