Post a New Question

physics

posted by .

This is going to be hard to explain, but here goes!

Four resistors, R1 = 30.0 ohm, R2 = 52.0 ohm, R3 = 93.0 ohm and R4 = 17.0 ohm, are connected to a battery with a terminal voltage of 18.0 V, as shown in the figure below.
____R1____R2__________
| |
|_______R3_____________|
| |
|___R4____ -(18 V)+____|

(that was the best i could do..)

Determine the power lost in the R2 = 52.0 ohm resistor.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. physics (please check)

    A total resistance of 3 ohms is to be producd by combining an unknown resistor R with a 12 ohm resistor. What is the value of R and how is it connected to the 12 ohm resistor a) 4.0 ohm parallel b) 4.0 ohm in series c) 2.4 ohm in parallel …
  2. physics (please check)

    Four 20-ohm resistors are connected in series and the combination is connected to a 20 V emf device. The current in any one of the resistors is: A) .25 A B) 1.0 A c) 4.0 A D) 5.0 A E) 100 A My answer: A R= 20 + 20 + 20 + 20 =80 V= …
  3. physics

    the table below shows the values of the resistance, capcitive reactance and inductive reactance for five RCL circuits. in which circuit will the voltage lead the current?
  4. physics

    A series RCL contains 150 ohm resistor, a 1.75x10^-6F capcitor and inductance of inductor 0.035H and voltage of generator 60.0 Hz. Determine its total impedance. a) 1500 ohm b) 1900 ohm c) 1700 ohm d) 500 ohm e) 300 ohm
  5. College physics

    What is the potential difference across the 10 and 20 ohm resistor in the figure there is a battery of 15V with two in series resistors of 10 Ohm and 20 ohm
  6. science

    Three different resistors: 10 ohm, 20 ohm, and 20 ohm are connected in parallel, the overall resistance is:
  7. physics

    a 100 V DC signal is applied to four resistors as shown in Fig. 5. The values of the resistors are 20 ohm, 40 ohm, 60 ohm and 80 ohm. What is the voltage across the 40 ohm resistor?
  8. maths

    if two resistors of r1 and r2 ohms are connected in parallel in an electriccircuit to make a R ohm resistor, the value of R can be found from the equation 1/R= 1/r1+ 1/r2. if r1 is decreasing at the rate of 1 ohm/s and r2 is increasing …
  9. Chakote school solapur

    if three resistors are connected in parallel there are 10 ohm 20 ohm and 60 ohm to a battery of 12 volt then find the effective resistance ?
  10. Physics

    A 40.0 ohm resistor, 20.0 ohm resistor, and a 10.0 ohm resistor are connected in series across a 220-V supply. Which resistor is the warmest?

More Similar Questions

Post a New Question