Electrical

posted by .

A matching network consists of a length of T-line in series with a capacitor. Determine the length(in wavelength) required of the T-line section and the capacitor value needed (at 1 GHz) to match a 10-j35 ohm load impedance to the 50 ohm line.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Electrical

    A source with 50 ohm source impedance drives a 50 ohm T-line that is 1/8 of a wavelength long, terminated in a load Z=50-j25 ohms. calculate TL, VSWR, and the input impedance seen by the source
  2. Physics

    A 3.00 uF and a 5.00 uF capacitor are connected in series cross a 30.0V battery. A 7.00 uF capacitor is then connected in parallel across the 3.00 uF capacitor. a)Calculate the equivalent capacitance of the circuit I think the answer …
  3. physics

    A series RCL contains 150 ohm resistor, a 1.75x10^-6F capcitor and inductance of inductor 0.035H and voltage of generator 60.0 Hz. Determine its total impedance. a) 1500 ohm b) 1900 ohm c) 1700 ohm d) 500 ohm e) 300 ohm
  4. physics

    a 500.0 ohm resistor is connected in a series with a capacitor.what must be the capacitance of the capacitor to produce a time constant of 2.00 s
  5. physics

    The load across a 12 V battery consists of a series combination of three resistors 21 ohm, 22 ohm, and 56 ohm. What is the total resistance of the load?
  6. Physics

    A capacitor network has two capacitors in series: 150nF and 120nF. The potential difference between point a on the outer side of the 150nF capacitor and point b on the outer side of the 120nF capacitor is 120nF. a) total charge of …
  7. physics

    The load across a 12 V battery consists of a series combination of three resistors 21 ohm, 22 ohm, and 56 ohm. What is the total resistance of the load?
  8. physics

    often it is highly desirable to minimize the impedance in a circuit. if the circuit contains a resistor, a capacitor, and an inductor, where the resistor and capacitor must be R and C respectively, and the inductor may have any value, …
  9. Engineering

    If you have a 300 ohm transmission line terminated with an antenna that presents a (400 ohm - j 600 ohm) load impedance: What is the normalized load admittance?
  10. Physics

    Consider an RC series CKT with V in series with RC. V=7 V, R=15 Ohm, C=0.0025 Farad. At t=0 we start charging the capacitor with no charge initially on the capacitor. (a) Calculate the time t∗ (in seconds) when the potential …

More Similar Questions