Post a New Question

Plastic Moulds ==> Couldn't find anything myself

posted by .

I'm proposed a way I'd synthesize plastic...polyethylene to shape into a pipe

PROBLEM: not sure how or what I would use to make a mold or best method to produce a PIPE

not sure what a mold should look like to produce a hollow object like a pipe. OR what material I can use around the house to make a good mold.

I saw silicon but I don't think they have silicon in the shape of a pipe...


HELP!!

Thanks

  • Plastic Moulds ==> Couldn't find anything myself -

    note: I need to find a mold that can be used at home..not industrial scale

    b/c presumably I'm a "poor college student" according to the HWK Q that asks us to create this pipe in the first place.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Physics

    One closed pipe organ has a length of 2.5 m. The frequency of the note is 34.3 Hz. When a second pipe is played at the same time, a 1.7 Hz beat note is heard. By how much is the second pipe too long?
  2. science(chem) plastic hedache...can anyone help?

    My hwk Q that I was trying to find the answer to yesterday is this below but I don't know exactly how the placticizing process works. I compiled the chemicals I think I need but other than that I'm stumped as to how to put them together …
  3. Physics

    I can't seem to figure out this problem...what equation would I use?
  4. Physics

    Water flows under pressure from one pipe into a second pipe having half the diameter. The volume flow rate in the narrow pipe is ________ that in the wide pipe, and the speed of the water in the narrow pipe is _______ that in the wide …
  5. Physics

    I was walking through my local home supply store the other day carrying a 10 ft length of plastic pipe. The pipe was horizontal and my hand was supporting the middle of the pipe. I noticed that when I took two steps each second the …
  6. Science

    Hi Just want to know if water from a 20mm Polyethylene pipe under pressure of 3 bars passes to a 25mm polyethylene will cause a slight increase in volume output with a little drop in pressure?
  7. Physics

    a plastic light pipe has anindex of refraction 1.53.For total internal reflection, what is the minimum angle of incidence if the pipe was in the air
  8. math!!!

    Molten plastic is injected into the centre of a circular mold of constant height, H, through a small hole. The rate of injection is such that the radius of the plastic inside the mould increases so that r(t)= 3t^2 -2t^3 where the mold …
  9. FLUID MECHANICS

    Air at 45°C is flowing steadily in a 25 cm-diameter horizontal pipe made of plastic at a rate of 900 l/min. Determine the head loss, and the required pumping power input for flow over a 175m-long section of the pipe.
  10. Math

    A thin plastic band 50 cm long is used to tie seven plastic pipes together. What is the radius of the pipe?

More Similar Questions

Post a New Question