Math
posted by Mike .
A 1/2 inch drill bit is too large for a job, while a 3/8 inch bit is too small. What size bit should be tried next?
7/16
*** 5/16 ****
3/16
9/16
is this correct

Nope. You need to convert the drillbit sizes to 16th of an inch.
A 1/2inch drill bit is 8/16 inch. The 3/8inch bit is 6/16 inch. Which of your choices is between 6/16 and 8/16?
Respond to this Question
Similar Questions

Producing
well ya i have a question I left my notes @ school I need to know what quality is most pleasing to the ear when recording audio. I'm using a half decent studio here were I have to following options 2 channel, 16 bit, 44100 Hz (CD Quality) … 
Discrete Math
What is the probability that a fair coin lands Heads 4 times out of 5 flips? 
Math
Mr. Munoz has a 1/16 inch drill bit and a 3/32 inch drill bit. Which will make a bigger hole? 
Math
If a 3/8" drill bit is rotating clockwise at 1300 RPM and the bit shatters, at what speed will the projectile be traveling outward? 
Physics
A dentist causes the bit of a highspeed drill to accelerate from an angular speed of 1.20 104 rad/s to an angular speed of 3.14 104 rad/s. In the process, the bit turns through 1.92 104 rad. Assuming a constant angular acceleration, … 
Physics
A dentist causes the bit of a highspeed drill to accelerate from an angular speed of 1.20x10^4 rad/s to an angular speed of 3.14x10^4 rad/s. In the process, the bit turns through 1.92x10^4 rad. Assuming a constant angular acceleration, … 
Computer
You have an empty 64 bit PCI slot in your computer. What can you install in it? 
physics
A dentist causes the bit of a highspeed drill to accelerate from an angular speed of 1.50 x 104 rad/s to an angular speed of 3.76 x 104 rad/s. In the process, the bit turns through 3.13 x 104 rad. Assuming a constant angular acceleration, … 
Math
You have a 5/16 in. drill bit. Will it drill a hole large enough to fit a 5 mm bolt? 
Physics uncertainties
A flat head drill bit is used to drill holes of small depth. The drill bit can drill holes with a diameter size of (40 ± 0.5)mm. The depth of the hole has an uncertainty of ±1mm. If the total percentage uncertainty of the volume …