electrical trade theory. S.O.S..!!!!!!!

posted by .

HI MY PROBLEM IS THE FOLLOWING...

HOW WERE THE MAIN DIS ADVANTAGES OF A SHUNT AND SERIES MOTOR OVERCOME?...

COMPARE THE LOAD CHARACTERISTICS OF A SHUNT, SERIES AND COMPOUND WOUND MOTORS...

HOW DO THE FIELD WINDINGS OF A COMPOUND WOUND MOTOR DIFFER FROM THE FIELD WINDINGS OF A SHUNT AND SERIES WOUND MOTOR?..

http://zone.ni.com/devzone/cda/ph/p/id/47

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. electrical trade theory

    what r the 2 main characteristics of a shunt connected motor?
  2. electrical trade theory. Help n Hurry!!!

    hello i'm struggeling with the following questions... Compare the no load speeds of shunt and series connected motors?
  3. Excel Help

    3) __________ are used to compare sets of data in one chart. Time series Multiple data series Relative series Comparison series Is multiple data series
  4. energy conversion

    A 5hp 230volt shunt motor takes 18 amp when operating at full load. The Shunt-field resistance is 115ohms and the armature resistance is 0.25 ohm. calculate the value of the starter resistor if the armature current is limited to 1.5 …
  5. Physics

    An electrical motor is designed to operate on 34 V at 1.3 A. How much resistance must be connected in series to this motor, if you wish to plug it in to a 120 V outlet?
  6. physics

    The ammeter your physics instructor uses for in class demonstrations has a resistance R(g)= 60 ohms and requires a current of 1.0 mA for a full scale deflection. The same ammeter can be used to measure currents of much greater values …
  7. Solar Energy Help ASAP

    Below you see a plot of an ideal and a non-ideal JV curve. Based on this plot and assuming an irradiance of 1000W/m2, give approximately the numerical values to the questions bellow: I. Estimate the ideal Fill Factor (in %): II. Estimate …
  8. physics

    An electric motor runs at a constant rotational frequency of 3000 r/min and has the load of 75 Nm and a 5,0 Nm extra load of friction and gear. The efficiency of the motor is 78%. a) What is the input power of the motor?
  9. Electrical trade theory N2

    What are the functions of the brushes in a dc motor?
  10. Physics

    An electric motor runs at a constant rotational frequency of 3000 r/min and has the load of 75 Nm and a 5,0 Nm extra load of friction and gear. The efficiency of the motor is 78%. a) What is the input power of the motor?

More Similar Questions