Questions LLC
Login
or
Sign Up
Ask a New Question
Questions
Science
In DC which wire will lose more enrgy 5m copper or 5m aluminium?
1 answer
For wires of equal diameter and length, alumimum will have the higher resistance. When connected across the same voltage source, the aluminum wire will convert less energy to heat, because less current will flow.
You can
ask a new question
or
answer this question
.
Similar Questions
9. Figure shows an aluminium wire of length 60 cm joined to a steel wire of length 80 cm and stretched between
two fixed
Top answer:
Hint: Stress in steel = 40N/1mm^2 Stress in aluminum = 40N/3mm^2 Speed of sound =
Read more.
a copper wire with a diameter of 1.5mm is joined to an aluminium wire which has a diameter of 2.3mm.the wire carries a current
Top answer:
As I recall, current density is I/a, where I is the current, and a is the cross-sectional area. So,
Read more.
A copper wire and an aluminium wire have length's in the ratio 3:2.diameters n the ratio 2:3 AND FORCES APPLIED IN THE RATIO 4:5
Top answer:
X = Length increase = L*Force/(Area)(Y) Y is Young's modulus X(copper)/X(aluminum) =
Read more.
160 kg of alloy of copper and aluminium contains 55 percent of aluminium.how much aluminium must be melted into it to make
Top answer:
.55*160 + x = .70(160+x)
Read more.
Suppose that you wish to fabricate a uniform wire out of 0.900 g of copper. Assume the wire has a resistance R = 0.500 , and all
Top answer:
You have two simultaneous equations to solve, and they depend upon the resisitivity and the density,
Read more.
1) Suppose that you wish to fabricate a uniform wire out of 1.15 g of copper. Assume the wire has a resistance R = 0.600 , and
Top answer:
To solve these problems, we can use the equations for resistivity and current. The resistivity of
Read more.
1) Suppose that you wish to fabricate a uniform wire out of 1.15 g of copper. Assume the wire has a resistance R = 0.600 , and
Top answer:
1) To find the length of the wire, we can use Ohm's Law, which states that resistance (R) is equal
Read more.
4. Lillian speaks to her father over a rope telephone consisting of two cans linked together with a 1,5 m length tight drawn
Top answer:
4.1 To calculate the speed of sound through the copper wire, we can use the formula for speed: speed
Read more.
A copper wire has a circular cross section with a radius of 3.75 mm.
If the wire carries a current of 4.00 A, find the drift
Top answer:
21
Read more.
A copper wire has a circular cross section with a radius of 3.75 mm.
If the wire carries a current of 4.00 A, find the drift
Top answer:
To find the drift speed of electrons in the wire, we can use the formula: v_d = I / (n * A * q)
Read more.
Related Questions
When setting up an experiment, chemists might use copper wire to tie certain parts of the setup together. They do this to make
Consider two copper wires with the same cross-sectional area. Wire A is twice as long as wire B. How do the resistivities and
Two wires are identical, except that one is aluminum and one is copper. The aluminum wire has a resistance of 0.835. What is the
An insulated copper wire is wrapped around an iron nail. The resulting coil of wire consists of 240 turns of wire that cover 1.8
Two wires are identical, except that one is aluminum and one is copper. The aluminum wire has a resistance of 0.527Ω. What is
Jade has an iron rod around which she wraps copper wire. She places the device on a table near a compass. What will she observe
Robin has an iron rod around which she wraps copper wire. She places the device on a table near a compass. What will happen to
What is the length of copper wire is required to produce a 4mohm resistor? Assume the diameter of the wire is 1mm and that the
Copper has a breaking stress of about
3 × 10^8 N/m2. What is the maximum load that can be hung from a copper wire of diameter
A 55.0-g piece of copper wire is heated, and the temperature of the wire changes from 19 degrees C to 86 degrees C. The amount